 |
All New 4 Bolt Main Engine Block |
|
|
Brodix Single Plain Intake Manifold |
| |
Forged Steel Crankshaft |
|
|
1050cfm Carburetor |
| |
Forged Steel Connecting rods |
|
|
New High Flow Water pump |
| |
J&E Forged Pistons 9.6:1 Compression |
|
|
New Fuel Pump |
| |
Plasma - Moly Rings |
|
|
MSD Race Prepped High Energy Ignition Distributor w/ 53,000 volt coil Pak |
| |
Heavy Duty Double Roller Timing Set |
|
|
New Spark plugs gapped and installed |
| |
Canfield Aluminum Cylinder Heads 119cc |
|
|
8mm High Temp Resistant Silicone Wires |
| |
2.25/1.88 stainless steel valves, hardened valve locks, chrome moly retainers, Heavy Duty Valve Springs and Screw in Studs |
|
|
New Chrome Thermostat Housing |
| |
Custom Hydraulic Roller Camshaft Duration @ 050 255/265, Lift 629/629 |
|
|
14 Inch Chrome Air Cleaner |
| |
Hardened Seats for running Unleaded fuel |
|
|
PCV and Breather Installed |
| |
Hydraulic Roller Lifters |
|
|
New Fuel Lines and Gas Filter |
| |
High Performance pushrods (1-piece) |
|
|
Oil Filter, Dipstick and Diptube |
| |
Crane Rocker Rockers 1.7 ratio |
|
|
Mini High Torque Starter |
| |
Melling High Volume Oil pump |
|
|
Ignition Timing Set, Carburetor fully adjusted |
| |
Complete Fel-pro Gasket set |
|
|
Hot Run tested and dialed In place |
| |
High RPM torsional damper |
|
|
Free 40 minute installation DVD |
| |
New Flexplate for Automatic Trans.
(Standard Flywheel extra) |
|
|
Balanced , Blueprinted and Painted with a High Temperature Enamel Paint |
| |
Oil pan, Timing cover and Polished Aluminum Valve Covers |
|
|
Packaged and Crated for Shipment
|
